I have scaled down the Skadis to fit on to the build plate for a P1S, P1P and X1C. If you add one more row or column it wont fit. You might want to print this blocker that keeps the printing head from hitting the cutter when going into the exclusion zone. This wiki link will explain https://wiki.bambulab.com/en/knowledge-sharing/print-volume-limitations. I did accidently print it without the blocker in and it didn't effect it but that may because I tried to position it to the opposite corner from the restricted area as much as possible. If you do put in the blocker once the print has finished you will get an error that the print has failed but all you have to do is remove in and hit retry. Then it will go cut an unload the filament and complete the job. The print profile should have the exclusion taken out but let me know if that didn't carry over and I will try to update it

Six of these models will get you roughly one board that Ikea sells. You do lose some space with different connectors but you can also print as many of these and arrange them in much more unique ways. There is also some cost savings based on filament price. Below I have linked the parts I used to mount them since my model doesn't come with any hardware, but I have no affiliation to them.

-These wall mounts worked great for me. No issues and the caps snap on nicely

https://makerworld.com/en/models/19480#profileId-32716

-These board connecters worked in between panels and helped mount them together a lot easier. Some of the tolerance came out a little tight but overall worked with a little trimming and a little force

https://www.printables.com/model/479180-ikea-skadis-skadis-board-connect

I am also trying to make a solid Skadis accessory collection so check that out on my page. So far I haven't made all of them so I'm not sure if they all work but as I print them I will make reviews to acknowledge if they fit the Skadis or not. I will try to grow it as well