Pegboard holder for Centech 61593 multimeter by jadamsowers

jadamsowers

Tools>Other Tools

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 20% infill

2.7 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

I needed a pegboard holder for my Centech 61593 multimeter. It's nice for the price (I got it at Harbor Freight) but too bulky to fit in any of the existing multimeter pegboard projects I found. It would also make for a decent 'cup' for many other boxy items.

Print Settings

Printer:

Prusa i3 Mk2

Rafts:

Supports:

Resolution:

200um

Infill:

20%

Notes:

The cup's bottom is chamfered with a 45° overhang, so it shouldn't pose a problem to print.

I printed the backplate on its side with no support material. the bend in the hook is apparently gentle enough that the overhangs weren't a problem for my printer.

Your mileage may vary.

Post-Printing

Slide the baseplate into the back of the cup. There's .5mm of tolerance on each side, so add some glue if the pieces don't fit together as snug as you'd like, or sand the sides down if they're a little too snug.

Category: Tool Holders & Boxes

thingiverse