Nightstand Storage with Apple Watch Charger by NC-Designs

NC-Designs

Tools>Organizers

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.16mm layer, 2 walls, 15% infill

Designer

2.9 h

1 plate

4.6(14)

Open in Bambu Studio

Boost

135

102

Released

Description

This is a nightstand holder for miscellaneous storage and includes an apple watch charging dock. There is a slot for guiding the apple watch charging cord underneath as well. This thing includes a large primary storage (for pens, remotes, glasses, etc.) and a small side storage (for chapstick, listerine strips, etc.).

Comment & Rating (25)

@cynthiascreativ

Print Profile

0.16mm layer, 2 walls, 15% infill

This printed well but supports were overdone and hard to remove. wire slot could have been done without supports. Apple Watch usb didn’t fit in the slot without post processing. overall I would suggest a modification, but after post processing this fits well for what I needed.

The designer has replied

@NCDesigns

Thanks for the feedback, was the USB too wide or too long for you?

@cynthiascreativ

Replying to @NCDesigns :

The usb wasn’t deep enough the curve for the cord holder was in the way and we had to file it down to get it to go through. I hope that makes sense.

(Edited)

@NCDesigns

Replying to @cynthiascreativ :

That makes sense. I haven’t heard of anyone else having that issue - is your charging cord fairly new or maybe off-brand?

@hanbcool

Print Profile

0.16mm layer, 2 walls, 15% infill

(Edited)

@ivanjfeliciano

Print Profile

0.16mm layer, 2 walls, 15% infill

Worked great, only issue is that this is not made for the newest gen type c apple watch chargers. You can squeeze the new gen cable through it, but the actual puck doesn't fit tightly either. (double sided tape fixes this)

The designer has replied

@NCDesigns

Thanks for the review and the info, I’ll make a note of this in the part description.

@MS.MICHELLER

Boosted

Print Profile

0.16mm layer, 2 walls, 15% infill

printed well and I use it every night, wish the box was a little bigger but I like it overall

The designer has replied

@NCDesigns

Thanks for the review! You might be able to manipulate it in bambu studio to get the size you want by using the "cut" tool to separate the docking part from the main body and then just scaling the box in the XY. There are some pretty cool tricks I've learned from messing around in the software!

(Edited)