Printed these today on my P1S and they turned out great. I have a single AMS, so used only 4 colors. I'll yellow the eyes a bit with a marker later. Printed at .32 layer height with a .4 nozzle and did 4X to make a few for friends and reduce waste. In hindsight, I wish I'd turned on ironing for the top layer. It looks pretty decent, but could be better. The side that was on the plate looks fantastic (pic shows the difference). Note that I had to recolor both sides. There is some sort of error in the middle of the model that prevents coloring on the top from also affecting the bottom. I also noticed a few stray lines in the middle that were not the color I expected, but they are invisible on the final product.