Search models, users, collections, and posts
Beyblade X Bit - Elevate
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill, Tree (Auto)
Designer
31 min
1 plate
Detailed, Variable layer height
24 min
1 plate
Open in Bambu Studio
Boost
409
1021
113
12
2.7 k
1.8 k
Released
Description
The Elevate Bit from Beyblade X. Compatible with any Beyblade from the Beyblade X line.
Print with “Tree (Auto)” Supports, and keep Infill at 15%. There will be a bit of support on the inside part on the bottom (Where it is usually hollow) which you can remove with a small tool such as a toothpick.
I printed this with ELEGOO Basic PLA Sky Blue, but it should work with most PLA filaments. Be advised as these are 3D printed parts, so they can get worn out faster than official products (They still hold up pretty well).
Drop some suggestions below on what Bit I should upload next! Maybe even some suggestions for custom Bits…
Credit to Juuni on Tinkercad.
Boost Me (for free)
Boost me if you would like!
Comment & Rating (113)