It is a decoration designed to decorate the Christmas tree. It's very simple. The height is 8 cm and the width is 6 cm. Before printing, see the printing instructions. The model can be proportionally reduced or enlarged, but it is necessary to change the nozzles, adjust the height and width of the layer.
Printing instructions
The orientation of the print should be placed on the mat with the flat side and brim. It is intended for printing without supports. We print with a layer height of 0.3 and a nozzle of 0.4 and with a 5% area fill and 2 perimeters. In the picture I used Prusament PLA Gold filament. After printing and folding, it is necessary to glue the model. This model was inspired by the designer rorys3D. Well thank you.