JoyCon Controller Grip for Nintendo Switch
JoyCon Controller Grip for Nintendo Switch
Boost
143
261
69
Print Profile(2)
0.2mm layer, 3 walls, 10% infill
Designer
1.6 h
1 plate
0.2mm layer, 3 walls, 10% infill
1.5 h
1 plate
Open in Bambu Studio
Boost
143
261
69
14
465
638
Released
Description
This prints in place in one piece without any needed supports. Just take it off your print bed, insert a JoyCon and you're ready to play!
No specific print settings are needed, just adjust the infill percentage to make the controller as dense as you want. This will accommodate both the left and right JoyCon.
Comment & Rating (69)
All
Print Profile
0.2mm layer, 3 walls, 10% infill
top
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Had a minor issue that needs smoothing on the rear curved layers but overall amazing!
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
I have tested V1 and V2...😁
0
Reply
nice
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 10% infill
Printed great. Printed on textured PEI bed with Inland PLA+
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Alles prima geklappt, die Teile sind top
(Edited)
0
Reply
nice design 🫶🏻
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Fits perfect 👍🏻
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
works well!
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld