3D printable soccer ball by Morethan3D

Morethan3D

Tools>Gadgets

Print Profile(7)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.2mm layer, 2 walls, 15% infill

Designer

25 min

1 plate

5.0(4)

0.2mm layer, 3 walls, 15% infill

Designer

19 min

1 plate

4.3(7)

0.2mm layer, 2 walls, 15% infill

Designer

1.2 h

1 plate

4.3(6)

0.2mm layer, 2 walls, 15% infill

Designer

2.5 h

1 plate

4.0(4)

Click to see more

Open in Bambu Studio

Boost

118

144

404

417

Released

Description

This is a 3D printed football ⚽️ 🥅
Assembled from 12x pentagons and 20x hexagons

Want to explore more interesting models from us? Visit: https://morethan3d.com/

Assembly Instructions:

Parts required (refer to the photos below)

20x Hexagon Blocks (a)
12x Pentagon Blocks (b)
35x Small Pin (e)

Assembly process:

STEP 1a: Press-fit 5x Small pins into the holes of a Pentagon Block
STEP 1b: Press-fit 5x Hexagon Blocks to all 5x sides of the Pentagon block above. Use small pins to interlock all blocks together
STEP 1c: Press-fit 5x Pentagon Blocks to the sub-assembly from STEP 1b. Use small pins to interlock all blocks together
STEP 1d: Press-fit 5x Hexagon Blocks to the sub-assembly from STEP 1c. Use small pins to interlock all blocks together

At this point, you’ve built half of the soccer ball. Repeat the same steps as above to build the other half. To connect 2x halves of the sphere together, you can either use the small pins, or some 5mm dia x 3mm thick magnets.

soccer

3dprintable

gadget

Comment & Rating (31)

@athodyd

too loose，better to use some glue.

@mariannemp25

Print Profile

0.2mm layer, 3 walls, 15% infill

second was Nice to finish, two to go. thank you!

(Edited)

@LeesX1

Print Profile

0.2mm layer, 3 walls, 15% infill

Printed Well...Good fitting

The designer has replied

@Morethan3D

Thank you :)

@good4u

What an interesting design. I'm curious what advantages there are to printing the individual blocks + assembly versus just printing the whole ball.

The designer has replied

@Morethan3D

Thank you - it’s just more fun to assemble all the pieces together rather than printing the whole thing all together 😅🙏

@3DMosaic

It's very interesting design! I love it! Could you help provide an all-in-one print profile? So we can print them directly and will not miss any part.

(Edited)