I first made simple alteration to Droidski's design to fit this to Biltema Pegboard, but after a month of use, the lower thing holding the can in place, broke down. So I made the lower thingie stronger in this v2.

For some reason I made calculation error and the bottom screw hole is not in correct position, but the holder stays in place with just 2 top screws, so I didn't make correction. Yes, I accidently didn't save the project file...good thing this don't end the world.

Edit 27.8.2021: I needed couple more of these, so I edited the file so that all the screw holes line up now. It is the v3-file, and I took down the original file. Looks like originally I printed this with 30% infill, but now I did with 10% infill and 4 walls, and I think this is stronger now.

Notes:

Really doesn't need supports!

Use at least 4 walls!