Spool / Filament holder & hook

Finally a minimalistic industrial design storage solution for your filaments!

I got tired of all the options out there, that are very great design, no doubt, but didn't have the industrial design minimalistic look, that both functions as a functional solutions but also a piece of design that is beautiful in the room.

I hope i have done just what i said, but that is of course very subjective! :D

If you need any size adjustments to fit any size rod, let med know in the comment! I will adapt it and upload it here!

• The spool hook fits perfectly into a Bambu lab spool, and is slightly conichal to make sure it has a tight fit.
• The brackest hides the screws as much as possible. I have used some beautiful brass screws, but you can use black as well.
• I have emphasized the part lines as a design detail, so you can add your own personal touch to it.
• Therefor i have made 4 plates. One for each hook, one for the bracket & cap, one for multicolor cap.

You do need a rod of 25 mm, but i can adjust the size to whatever you feel like.

Hope you enjoy, and what ever changes need, let me know!

Assembly:

Screw on the wall bracket. Make sure the holes on the sides points directly to the left and right.

Attach the bracket to the wood rod or whatever you use. (print you own small one for single spool holder

Place the bracket over the wall bracket and fasten the screw on the side

When tighten you can place the cap and you are all done!