Print Profile(1)
0.28mm layer, 2 walls, 15% infill
Designer
26 min
1 plate
Open in Bambu Studio
Boost
1
5
1
0
6
7
Released
Description
I have a problem with misplacing my microphone when not in use so I created this little holder that allows you to sit it on top of the receiver when not in use.
NOTE: you may need to resize in your slicer after doing a test fit. I tuned this 3D model to print on my Bambu Lab X1C perfectly but no two machines are the same.
Happy printing!
Comment & Rating (1)
All
Print Profile
0.28mm layer, 2 walls, 15% infill
Amazingly helpful design! Is a bit tight of a fit (for me), but better than falling out :) works great!
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld