It works well enough, but I was a little disappointed in how the snap-fit pegs behaved. Two of mine snapped off with a clean shearline at the surface beneath them. I think this is an issue with the model and/or my filament being too brittle? Anyway the print profile is what i'm rating and I can't think of anything that could be changed in the profile to mitigate this issue, so it's a 5 star profile.

only issue I ran into was that two of the pins that hold the two parts together snapped, however the tool still works, so I'm chalking it up to user error.

prints well and they’ve come in handy while I’m working on another printers main board

Handy item stops me pulling the cables out,had to increase the infill needed bit more strength near the joins

Works well