Here are some nice removeable Spoolholders for your great Orca Printer :)
the tip of the lower spoolholer is made a bit longer so you can also put 100mm wide rolls on it , they won`t fall of anymore !
Only for 1,75mm filament !
This is a modification from Mendelparts original spoolholder.
Just print them and put them on your printer.
ensure that you printer is well tuned, they fit tight.
should fit PnP on most V40+
For V30 (and some early V40) you need to drill some holes and screws + nuts.
2x M3x10mm + nuts
2x M4x10mm + nuts
the upper part is made for 5mm teflon tube to fit in.