Sword handle for pool noodles
Copyright Claim
Sword handle for pool noodles
Boost
77
127
15
Print Profile(1)
0.2mm layer, 3 walls, 12% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
77
127
15
6
125
99
Released
Description
Flat print orientation for the best possible strength. No supports needed.
Print settings:
- For outdoor use, it's better to use PETG.
- For added strength, use these print settings: 3 perimeters, 3 bottom and 5 top layers, 15% gyroid infill.
Postproduction:
- Glue bot halves together using superglue, printed pins will help with proper alignment.
To complete the sword, screw the handle into the end of the pool noodle. Suitable for noodles without central hole. No drilling holes needed. Before you screw it all the way in, apply glue to the end of the thread to secure handle in place.
Comment & Rating (15)
All
Print Profile
0.2mm layer, 3 walls, 12% infill
Like for the overall design but the handle is not centered when you start to drill in the middle of foam noodle.
(Edited)
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 12% infill
Super clean!
0
Reply
Print Profile
0.2mm layer, 3 walls, 12% infill
Other Issues:it doesn’t fit together well but is still cool.
0
Reply
Print Profile
0.2mm layer, 3 walls, 12% infill
Perfect, Thanks!
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 12% infill
print went perfectly well. the dowels were great for gluing it together. Went down great in bambu Petg basic.
0
Reply
Print Profile
0.2mm layer, 3 walls, 12% infill
very strong. printed with abs.
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 12% infill
My son immediately requested I make one for all of his friends and cousins 😂
0
Reply
Print Profile
0.2mm layer, 3 walls, 12% infill
printed great, tip is real sharp.
0
Reply
Print Profile
0.2mm layer, 3 walls, 12% infill
Printed great. Thanks!
0
Reply
Print Profile
0.2mm layer, 3 walls, 12% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld