Hearing Aid Case (with desiccants)
Copyright Claim
Hearing Aid Case (with desiccants)
Boost
2
11
9
GIF
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
2.8 h
1 plate
Open in Bambu Studio
Boost
2
11
9
0
36
24
Released
Description
This is a hearing aid case. Printed in PETG or PLA. The inner screw has two sides - one side for the hearing aids, and one side for desiccants (silica gel balls) to control moisture.
Print so the desiccant side (shallower side) is face down. You will need supports for this part.
Watch video for assembly instructions…
Comment & Rating (9)
All
I like the design, but I had trouble with the threaded center part where one end didn't start quite right and couldn't be threaded. I had to manually sand it down to the right thread to get it going, and still could only get it half in.
The designer has replied
0
Reply
hmm, that's odd. I have only printed this one time and it worked for me just fine (as you can see in the video). Sorry for the trouble with the print! You could try scaling the "threaded center part" down by 0.5% and maybe that would give you some better tolerances?
0
Reply
Replying to @dfreshkremer
Most of the thread was fine, just the first one on the short end.
0
Reply
Replying to @corinos
When I get home, I will open up the file and take a look at the threads
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Works great, I suggest not using loose desiccant beads.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
printed this for my mom because she was traveling and it came out perfect!! thank you!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld