Bambulab P1S External Spool Support Extension
Copyright Claim
Bambulab P1S External Spool Support Extension
Boost
34
44
17
Print Profile(1)
Low layer height to reduce roughness and friction with the spool 0.12mm layer, 3 walls, 20% infill
2.3 h
1 plate
Open in Bambu Studio
Boost
34
44
17
1
145
101
Released
Description
An extension to allow the use of larger spools on the original spool support from BambuLab P1S
Comment & Rating (17)
All
Great. It helped.
0
Reply
Print Profile
Low layer height to reduce roughness and friction with the spool 0.12mm layer, 3 walls, 20% infill
printed well
thanks
0
Reply
Print Profile
Low layer height to reduce roughness and friction with the spool 0.12mm layer, 3 walls, 20% infill
prints great
0
Reply
Print Profile
Low layer height to reduce roughness and friction with the spool 0.12mm layer, 3 walls, 20% infill
had to clip the sides a little bit but overall really good quality. If you like using Amazons filament then you’ll definitely need this
0
Reply
Print Profile
Low layer height to reduce roughness and friction with the spool 0.12mm layer, 3 walls, 20% infill
Works great. Functional. Might fall off occasionally when changing spools.
0
Reply
This was just what I needed. I have a spool of Ninjaflex that despite being .5 KG is wider than 1 KG rolls. This gave me the extra length needed to securely hold the spool. Printed it laying down in same orientation it will be used. Tree supports. Duramic PLA+. I had to stretch out the metal spool holder just a tad to get it to snap into place. Once it snaps in it's quite snug and feels secure. Thank you for the model.
0
Reply
Print Profile
Low layer height to reduce roughness and friction with the spool 0.12mm layer, 3 walls, 20% infill
0
Reply
Print Profile
Low layer height to reduce roughness and friction with the spool 0.12mm layer, 3 walls, 20% infill
0
Reply
Print Profile
Low layer height to reduce roughness and friction with the spool 0.12mm layer, 3 walls, 20% infill
0
Reply
Print Profile
Low layer height to reduce roughness and friction with the spool 0.12mm layer, 3 walls, 20% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld