Grogu Phone Stand
Grogu Phone Stand
Boost
173
269
53
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
3.7 h
1 plate
AMS 0.16mm layer, 2 walls, 15% infill
33 h
1 plate
Boost
173
269
53
8
521
286
Released
Description
I designed a Grogu Phone holder.
Comment & Rating (53)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Der Druck war meiner Meinung nach sehr gut. Nur war ich bei den Stützen nicht vorsichtig genug an der Hand.
Oder schuld war das es schon kalt war. Hab zu lange gewartet.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great phone holder. print comes out great but the supports are to tight around the right hand and on both prints the hand snapped off
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very good model
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
love it
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
está perfecto en el ángulo bueno
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
easy print. holds my phone perfectly I might make it again in green
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I’m not sure if it was intended but my grogu snapped off with supports. way to heavy. took his right hand. next time try organic supports. so good but could be tweeked to be much better.
ps. let me know if you change supports to organic and I’ll download again
2
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld