HygroStand

HYGROSTAND

Required Accessories:

• 1x Hygrometer (D=44 mm): LINK
• 1x Washer 13 x 37 x 3 mm

Printing instructions:

Make sure that you don't print the item upright!
The print quality would suffer. Tilt it at an angle of 45°and use tree support.

Assembly:

1. Insert the washer into the bottom part.
   This provides additional weight so that the holder is more stable.
2. Connect the upper part to the lower part.
3. Insert the hygrometer and turn it into position.

It should fit without glue. Of course, you can also use a drop of glue to hold the parts in place.

Have fun!