I saw a red bow posted on Reddit like this. It was kinda small and plain, but I really liked the idea so I decided to go bigger and more ornate. This model uses about 18 grams of filament and takes a little under 2 hours to print in ludicous mode. The profile I've included here is great for getting the best results out of silks while still being able to handle ludicrous mode without a steep drop off in quality. The best part is that the center post is a screw for the retention button so no glue or creases required. Regular gift ribbon can be used to tie it to a box or it can be hung as an ornament.
I suggest using the profile I have here. But if you wanna use your own settings I understand. If you do use your own profile, or print on something other than a Bambu printer, I at least suggest using the following guidelines:
3 walls
3 solid top/bottom layers
0.2mm first layer
0.1mm layers after that (Petals are 0.4mm thick and this ensures pliability and strength)
10% infill
Please rate, review, and share your makes! I look forward to seeing them.