Airbus Dimmer Knob
Copyright Claim
Airbus Dimmer Knob
Boost
9
20
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
16 min
1 plate
Boost
9
20
3
1
70
11
Released
Description
This knob is all over the airbus aircraft as a dimmer knob
You will find recess holes, these are a guide to where the grub screws need to be, you will need to drill these out further. I have also not placed a centre hole on the bottom of the knob, due to some people needing D shaped holes and others circle.
The grub screws are at a 90 degree angle to the center
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Good.
(Edited)
0
Reply
Boosted
Good job
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I printed two of these neither one of them had any issues the first one was for measurements to scale up the second one
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld