X3D AMS Riser Lite 58mm high
Copyright Claim
X3D AMS Riser Lite 58mm high
Boost
62
99
26
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
14.2 h
2 plates
Boost
62
99
26
1
240
171
Released
Description
Check my FB group if you need more info after reading below.
Again a riser but this time one which is in line with the outer lines of the machine.
I have tested it with the X1C and the P1S and glass fits perfect.
You will need 4 top connectors and 4 bottom connectors to fuse the 4 sides together.
Print in aby filament of choice, ABS, PETG for higher temperatures or just PLA/PLA+ for daily PLA use.
Led driver used for this riser is a Zigbee 12v non-rgb
Comment & Rating (26)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
top👌🏿🙃Thanks🙏🏿
The designer has replied
0
Reply
Love it, looks awesome
(Edited)1
Reply
Replying to @DutchWorkX3D
🙃🙏🏿🙏🏿Thanks so much
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
work great!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great print, but I used Support.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I can't say enough about the quality of this print and profile. Very well done!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect fit. I stayed with single color for simplicity. Thanks a lot for this model!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Manual global supports are enabled, but Plate 2 is missing supports by default, which of course causes a print failure if you don't catch it.
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Partially my fault, but plate 1 printed great with supports and I didn't realize plate 2 didn't have supports...so, yeah. I'm still using it, but I was disappointed with the results.
(Edited)2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Broke on me. Im planning on doing a different modle.
(Edited)1
Reply
When using the full plate area on X1C the chain frequently knocks and damages the internal right side where the LED's would go.
The designer has replied
0
Reply
I know the chain is touching the leds but did not have any issues yet.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Tutto bene :)
(Edited)0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld