iFixit Multi Bit Offset Screwdriver (4mm)
Print Profile(2)
Description
A quick 30 minute print offset wrench for the ifixit toolkit bits or other 4mm bit sets. Useful for tight spaces that need hand torque. It was designed with using the short end, but put a 4mm slot on both ends. If you have the ifixit set it can fit inside the case loose. Image contains the measurements. 25mm x 85mm & 10mm thick at its widest point.
Prints with no support with standard PLA.
IMPORTANT: First time use it you'll want to prime the hole with a bit first. You WILL want to have pliers on hand but it should fit better after pressing the bit in and removing it a couple times. Profile uses a .1 mm layer height since the tolerance levels are so low for the 4mm bits.
Boost Me (for free)
Thank you for checking out my prints, hope you have a great rest of the day 👍
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (45)