Backdrop Mount Holder

This is a backdrop roll holder intended to be used with a backdrop on a roll with a 2" inner diameter. You can then rest the handle on a tripod or wall mount to roll the backdrop down from.

The parts are separate to allow for easy printing without support and utilize a screw to assemble and provide strength perpendicular to the layer direction, as force will be applied along layer directions during use. The part is also meant to be flexible, so PETG, or another flexible filament, is recommended.

For assembly, insert a M4x100mm screw through the top (as oriented in the file) of the handle, thread through, and screw though into the bottom of the insert. Once tightened, insert into the end of your backdrop. Repeat for the other side of your backdrop roll.