Toroidal Propeller "Dupio" 4 Strong Flying Copter Toy
Copyright Claim
Toroidal Propeller "Dupio" 4 Strong Flying Copter Toy
Boost
116
292
75
Print Profile(4)
0,2 mm Layer height "Strength", Rest same as Quality File.
Designer
49 min
1 plate
Quality Print. Good ratio Weight/ Strength & Seams set to avoid weak points.
Designer
57 min
1 plate
Flying Prop Dupio PETG
Designer
39 min
1 plate
Strong! 6 walls, 25% infill
49 min
1 plate
Open in Bambu Studio
Boost
116
292
75
17
760
507
Released
Description
Heyho :)
Here I have a Deisng iteration to my toroidal Propeller for the Flying Propeller i already designed.
In addition to this Propeller you will ned the Handle with all internals and the pulling Rod:
https://makerworld.com/de/models/62388#profileId-70037
It is a lot heavier but due to the increased surface it will lift up quite good too and it looks very majestic!
As with the basis version I prefer stiff, light and robust materials for these rotors. I print them with PA6CF Filament. But everything else will work too.
Printing Tipp:
Locate the seams at the center piece to get a good airflow and connection between the connection points .)
Comment & Rating (75)
All
Print Profile
Strong! 6 walls, 25% infill
great look, feel, and very durable!
The designer has replied
1
Reply
Thanks for sharing! Looking good!
(Edited)1
Reply
Print Profile
Strong! 6 walls, 25% infill
prints greate
The designer has replied
0
Reply
Thanks for sharing! Looks nice!
0
Reply
Boosted
Print Profile
Strong! 6 walls, 25% infill
printed it so easy
0
Reply
Boosted
Print Profile
0,2 mm Layer height "Strength", Rest same as Quality File.
Looks really good and is a little bit heavier than the regular ones.
(Edited)
0
Reply
Print Profile
0,2 mm Layer height "Strength", Rest same as Quality File.
Good print.
0
Reply
Print Profile
0,2 mm Layer height "Strength", Rest same as Quality File.
Printed three of these, every one is amazing
0
Reply
Print Profile
Strong! 6 walls, 25% infill
Excellent design, thank you for sharing.
0
Reply
Print Profile
Strong! 6 walls, 25% infill
love this. prints fast and flys high!!!
0
Reply
Print Profile
0,2 mm Layer height "Strength", Rest same as Quality File.
The entire set of rotor and handle made a grumpy kid very happy. They are playing with it even two months later
The designer has replied
0
Reply
TY! That is good to hear :P Have lots of fun with it!
0
Reply
Print Profile
0,2 mm Layer height "Strength", Rest same as Quality File.
der geht mal richtig gut 😄
The designer has replied
0
Reply
viel Spaß damit :)
0
Reply
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld