A nozzle for a no-name grease that comes with printers. Makes the application of grease easier.

I received this one with FLSUN V400. It's a nightmare to grease the rails with such short tip.

Printing instructions:

Material: PLA

Layer height: 0.2mm or less

Walls: 3

Infill: 10-15

Brim: Yes

After printing:

Make sure that there are no blobs inside the nozzle → Use a needle a push it through

Cut a tip of the grease - check photo

Put the nozzle on the grease, squeeze - it will take a little bit of force for the first time, before the grease comes out of the nozzle