Gridfinity 1.24mm Wall Divider Bins with Label Shelves - 4 Sizes Remixed by KYZ Design

Remixed by

KYZ Design

Tools>Organizers

Print Profile(3)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

Monochrome, PLA/PETG

Designer

3.7 h

4 plates

4.9(41)

Acccent Lip, PLA/PETG

Designer

3.8 h

4 plates

5.0(28)

6 height Starter kit/0.24mm layer, 2 walls, 15% infill

8.8 h

1 plate

5.0(3)

Open in Bambu Studio

Boost

111

368

772

780

Released

Description

1.24mm thick walls - 0.4mm nozzle will do this in 3 passes, 0.6mm nozzle will do this in 3 passes
Slightly deeper than standard bins
No magnet holes
Minor changes to internal chamfers and internal overhangs for printability
12mm radius scoop for 3 unit tall bins and 24mm radius scoop for 6 unit tall bins
9.5mm label shelves for 9mm labels

Check out this collection for my other Gridfinity models (including the super clean grid!) and

check out this collection for my other Honeycomb Storage Wall models.

gridfinity

bin

Comment & Rating (79)

@NoWayOut1980

Print Profile

Monochrome, PLA/PETG

Top 😎

@cm_dubz

Print Profile

Acccent Lip, PLA/PETG

the accent lip is a very nice touch. thank you!

The designer has replied

@KYZDesign

you’re welcome :)

@marcusr

Very nice bins. However, when stacking these, the bin on top rests on the label shelf rather than the edge of the lower bin. I believe the label shelf should be lowered ever so slightly. Also, a few larger sizes would be nice for longer screws etc, like 1x3 and 1x4!

(Edited)

The designer has replied

@KYZDesign

I did notice the stacking on the label shelf but I didn’t change it because the original design does that.. in hindsight, I should have. But don’t worry, you won’t notice soon enough! haha. I’ll add some sizes when I get a chance :)

@Hierotochan

Print Profile

Monochrome, PLA/PETG

Quick print, smooth sides and ramp inside. Would be better with magnet holes even if you’re not going to use them, the base is thick enough that it wouldn’t weaken it to have them.