Shower Squeegee Mount by TimGilbert

TimGilbert

Household>Other House Models

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

34 min

1 plate

4.7(3)

Open in Bambu Studio

Boost

Released

Description

This allows you to put double sided tape onto the back and mount in a shower to hold a squeegee that is roughly 30mm wide at the neck.

squeegeehanger

Comment & Rating (5)

@TeMoney

Print Profile

0.2mm layer, 2 walls, 15% infill

its was kinda hard to remove the supports but looks good!

@Tigerchen

Print was fast and easy. Support was also easy to remove with some pliers and just a little careful wiggling. The back could be easily pulled out with a Scalpel. Looks absolutely beautiful. Thanks for sharing this file.

@ohgoddamn

Print Profile

0.2mm layer, 2 walls, 15% infill

supports were a little hard to get off at first, but printed exactly how I needed it

The designer has replied

@TimGilbert

That's nice to hear. I wanted to make sure that the base is flush to discourage water from getting to the 3M tape so I put a 1mm inset section to allow for that. the supports also mean that that area is rough which is a side benefit for good adhesion.