Base shell for magnetic levitation kit
Print Profile(3)
Bill of Materials
Description
This is a small size case for the base of the Magnetic Levitation Kit. Compared to the original protective case of the Maglev kit, this case has a new power connector and switch mounting location for more completeness and convenience. Two versions are provided, switch on top and switch on side, to fit different sized models.
It's perfect for displaying Pokemon models born from the PrintMon Maker, and is also great for hovering to display artifacts, small props, artwork, and more. If you don't have any special requirements for the appearance of the base, you can just use this shell model. If you have special requirements, you can also adjust your own design.
Installation：
1. Press to open the four snaps and remove the kit from the protective case.
2. Place the kit into the base in the orientation shown, noting that the round holes in the corners of the kit should go through the columns.
3. After adjusting the nut to the proper position, insert the power connector into the notch.
4. Attach the flat side of the touch switch to the switch position with double-sided tape or glue. Be careful not to pull strongly on the touch switch.
5. Organise the wires into the gaps and close the cap.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (189)