Search models, users, collections, and posts
Light Cage
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.4 h
4 plates
Open in Bambu Studio
Boost
13
28
1
1
23
11
Released
Description
This light cage does not need support.
I printed it with Elegoo Rapid PLA plus, white filament.
I am not familiar with Elegoo settings. So the product is not good enough. I use a 2mm drill bit. And the Lepage super glue to glue them together.
I have another design with two parts only. But it needs support and overhanging is so annoying.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)