The Tough Mason - Printed in standard mode

The Tough Mason - Printed in standard mode

Boost
50
68
30

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
4.9(22)

Boost
50
68
30
1
223
127
Released

Description

This version of my mason jar prints in standard mode (not vase mode) to allow it to be more rigid and watertight.

 

My test print was able to hold water with no issues.

 

See my models page for a lid to fit this model.

Comment & Rating (30)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
Sturdier than the vase mode one. Works well. Printed with clear PLA with some noticeable ringing. I should probably clean my Z-axis screw...
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very easy to print and nice design.
(Edited)
0
Reply
Very nice jar. Fast printing and good quality!
0
Reply
Is this the biggest jar that you make? I am printing on the A1 mini.
(Edited)
The designer has replied
0
Reply
If you want BIG - I'd recommend this one https://makerworld.com/en/models/79550#profileId-84179 If you want TALL - this is it https://makerworld.com/en/models/52187#profileId-53997 All of my jars can be found here - https://makerworld.com/en/u/369067369/collections/152381
(Edited)
0
Reply
can I use standard mason jar lids/printed mods with it?
The designer has replied
0
Reply
Sure can.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice print on a1
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
impressive
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Had to scale up by 1% to get a good fit with a standard Mason jar lid but that is likely just differences in filament/printer. Great design!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
sehr gut sehr schnell druckbar und 1a Qualität Danke
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thanks @Variable - and love your handle.
0
Reply