Cute Sitting Skeleton

⚠️ If you want to see all my models (i.e. middle fingers), turn on nsfw in your account settings under preferences⚠️

Hey everyone. Meet Toby, the cute and plump little skeleton who loves just sitting around and watching the world go by.

Toby has a poseable head and comes in two sizes: 4.5cm (1.8") and 5.5cm (2.2") (sitting height). There are also three different eyes to print.

Works great with glow in the dark filament as well.

Happy printing!

NB: The body and neck pin is compatible with my Bunny Art toy model

Printing notes

• The standard print results in a little unevenness on the top of the leg, but this has the least amount of supports. If you want to a perfect leg quality, but more supports to remove, then choose the “Better leg quality” plates to print.

Building Instructions

• Fit the neck pin into the body. This is designed to be tight so it takes a bit of effort to get in. If you can't use your thumb, then press it down against a table. You can usually hear a couple of clicking sounds as it goes in.
• Push the head down on to the neck pin. If there is a gap between the head and the body, then the neck pin needs to be pushed further into the body first.

• Eyes need to be glued. Though they generally fit either side, you will get a better fit if you pay attention to eye orientation and direction. Each eye has a “L” and “r” on the back to that aligns with the image below. The markings a bit hard to see, but they are there.