Introduction:

Are you still using cardboard boxes to store your nozzles?
Here is a stylish solution for everyone who likes mechanical and eye-catching builds. It is not only easy to print, but also to assemble.

This is a christmas themed hotend holder, which can store up to six hotends, revolves around its axis and will look pretty good in your room.

Print:

Everything can be kept at the default settings for bambu printers with a 0.4mm nozzle and 0.2mm layer height, except for Basket and Plug, where the layer height should be 0.08mm.

IMPORTANT!

You have to make sure to choose the correct baskets and rheindeer antlers!

Assembly:

The assembly is really easy:

Ferries Wheel

1. Put one snowflake with the smooth side on the table.
2. Place the six baskets one after another at their spots and secure them with the plugs (be cautious to orientate them correctly).
3. Now put the rod through the hole in the middle and press it in until it stops (you should see a bit from the chamfer on the smooth side).
4. Now the second snowflake can be placed on top and everything should line up (don't forget to plug the other side).
5. Now you can put the assembled wheel in the stand.
6. Put the stars on top of the stands.

Rheindeer Antlers

You should shove them in from the side, where the nozzle size is written on.

Now you should have a finished project! ENJOY!