Olaf
Copyright Claim
Olaf
Boost
266
461
151
Print Profile(2)
0.16mm layer, 2 walls, 15% infill tight fit
Designer
3.7 h
3 plates
0.16mm layer, 2 walls, 15% infill
4.4 h
3 plates
Boost
266
461
151
5
1.2 k
2.1 k
Released
Description
Hellooo
here is a nice model of Olaf. I didn't know whether I should mark it as original because it's from the film, but from what I've seen of the others, everyone makes it so original.
Everything is made up of individual parts so that you can print it beautifully and colorfully without ams. I hope you like it, share it with friends and relatives and have fun.
Feel free to visit my page to see other cool models.
Comment & Rating (151)
All
I had to print the connector between middle part and head, the arms, as well as the eyes again in a few percentage points smaller, as I was not able to fit them together in 100%. The nose e.g. was no problem at all. So overall the black parts seem to be a little tight.
But I really like the result.
5
Reply
I printed Olaf at 100% and added an ice flow that serves as a pencil holder for the Apple Pencil.
To make sure that Olaf does not fall off the ice flow I inserted a 10mm Magnet into one of his feet and also into the ice flow.
Another magnet is under the groove for the pencil to keep it in place.
The designer has replied
1
Reply
nice loks greate!🥰
0
Reply
would you be kind enough to share the ice file? thank you!
0
Reply
Replying to @user_3683516958
i remodeled the ice from this one:
https://www.thingiverse.com/thing:2921260
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill tight fit
fun print i did the snow in glow 😃
2
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill tight fit
so cute!
However, the connection between the head and the body is a large, too tight to install, would you like reduce the size of the connection( black square).
The designer has replied
1
Reply
ok. ty for you fedback. i change it
(Edited)1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill tight fit
Awesome print. Granddaughter going to love it. Thanks much.
The designer has replied
1
Reply
I'm very happy to hear that🤩🥹
0
Reply
nice
The designer has replied
1
Reply
nice look great now i want this lego santa😂😁
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill tight fit
Very Cute. Body joint is a little bigger, but no real issue, little bit of sanding.
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill tight fit
A very good design,but I struggled to install his right hand
1
Reply
Such a great model!
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill tight fit
Very nice print. Everyone should have an Olaf like that
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld