Reddit Request

Project: reddit hueforge.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 130x162.5mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 3mm and the Actual Depth is 3.1mm

Filaments Used:
PLA PolyLite Black Transmission Distance: 0.3
PLA BambuLab Matte Dark Blue Transmission Distance: 1
PLA BambuLab Matte Dark Red Transmission Distance: 1.5
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Beige Transmission Distance: 8
This print uses 6 unique filaments

Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Dark Blue
At layer #13 (1.12mm) swap to Dark Red
At layer #20 (1.68mm) swap to Orange
At layer #24 (2mm) swap to Yellow
At layer #32 (2.64mm) swap to Beige for the rest.