Search models, users, collections, and posts
ZIP STOP
IP Report
Print Profile(1)
0.2mm layers, 2 walls, 10% Gyroid infill (TPU)
Designer
44 min
1 plate
Open in Bambu Studio
Boost
4
7
5
1
10
6
Released
Description
This was created to help stop zippers from destroying your cardboard body tube of your model rocket during parachute launch/recovery. This will help distribute the load of the shock cord over a wider area along the edge of the body tube.
- Weave the cord through the holes in the zip stop.
- position it about halfway along the edge (centered) of the body tube when the shock cord is tight.
- Add a knot before and after the zipstop to prevent it sliding from parachute ejection.
- add parachute and recovery system as usual.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)