Apple AirTag Key Ring Holder
Copyright Claim
Apple AirTag Key Ring Holder
Boost
17
21
12
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
22 min
1 plate
Open in Bambu Studio
Boost
17
21
12
0
65
70
Released
Description
This is a press-fit Apple AirTag key ring holder. Print using TPU or you will likely not be able to get the AirTag into the key ring holder. If the TPU or other flexible filament is too soft/flexible, it may not hold correctly either. For my uses, I printed with Pyroflex TPU as well as with SainSmart TPU.
Comment & Rating (12)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
Needed to dry my TPU first then it printed great.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
clean!
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
my first TPU print, came out well, no issues. very tight fit, but eventually you can get the airtags in. nice job!
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Habe es in TPU gedruckt, AirTag hält sehr gut und Fest in der Hülle
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
usefull print
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Great print with TPU95
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
top!
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
fits perfect thank you
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld