Almond Blossoms decorative picture

Inspired by Van Gogh's Almond Blossoms

After framing, this piece can be used as a fridge magnet or decorative wall art.

The original piece was printed using a 0.2mm nozzle at a 0.06mm layer height, totaling 32 layers and taking 19 hours to complete. Due to the large file size, the slicing file cannot be uploaded. To print with a 0.2mm nozzle, please download the STL file and refer to the slicing settings below.

Materials Used:

Bambu PLA Series:

• Blue Gray (PLA Basic Blue Gray)
• Orange (PLA Basic Orange)
• Ice Blue (PLA Matte Ice Blue)
• Jade White (PLA Basic Jade White)

Slicing Guide:

For 0.4mm Nozzle:

• Use a 0.12mm layer height for a total of 16 layers.
• Change materials at these layers:
  • Base: Blue Gray
  • Layer 4: Switch to Orange
  • Layer 6: Switch to Ice Blue
  • Layer 9: Switch to Jade White
  • Continue printing with Jade White for the remaining layers.

For 0.2mm Nozzle:

• Use a 0.06mm layer height for a total of 32 layers.
• Change materials at these layers:
  • Base: Blue Gray
  • Layer 8: Switch to Orange
  • Layer 11: Switch to Ice Blue
  • Layer 17: Switch to Jade White
  • Continue printing with Jade White for the remaining layers.

For other nozzles and layer heights, please adjust proportionally.

Operating Instructions:

With AMS: After the initial slicing, right-click on the relevant layer in the right layer bar, select Change Filament, and set material changes on layers 8, 11, and 17. Re-slice after setup.

Without AMS: After the initial slicing, right-click on the relevant layer in the right layer bar, select Add Print Pause, and set pauses on layers 8, 11, and 17. Re-slice after setup. The machine will pause at each designated layer during printing; manually change the filament and resume printing until the next pause.