NOTE!The tolerance of the model is 0.3, please confirm before printing!
The holder may need to be fixed with double-sided tape
After purchasing many BambuLab printers, I started to need some number plates to manage the printers!
The MakerLab system just happened to be online!
I usually partition the printer, so I designed areas A to D, each with 10 numbers.
The holder needs to be assembled after disassembling the screen.
If it is too loose, you can use double-sided tape on the wider upper and lower areas to secure it.
MakerLab currently does not seem to support sharing completed templates.
So if you have any numbering needs, you can tell me in the comment area. I will take the time to help you make it.
I originally wanted to use purple or green, but unfortunately I don't have these two colors now. So as you can see in the photo, I used orange for test printing.
If you want to make your own version, you can refer to the dimensions in the image below.
The base plate thickness is 8mm / R7.
----------中文解說----------
注意!模型的公差為0.3mm請確認之後再進行打印.
holder可能會需要使用雙面膠帶固定.
持續的購入了許多BambuLab的打印機後開始需要一些號碼牌來管理打印機了!
剛好MakerLab系統上線了!
我通常會把打印機做分區,因此我設計了A到D區,各10個編號.
holder需要拆下螢幕後組裝.
如果太鬆,可以在上下較寬的區域使用雙面膠帶固定.
MakerLab目前似乎不支援分享製作完成的模板.
因此如果您有編號上的需求,可以在評論區告訴我.我會抽空幫您製作.
我原本想用紫色或綠色,可惜我現在剛好沒有這兩種顏色.於是如照片所見,我使用了橘色來做測試列印.
如果你想要製作自己的版本,可以參考上方英文說明內圖片的尺寸.
底板厚度為8mm / R7.