Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
9 min
1 plate
Open in Bambu Studio
Boost
45
63
7
1
59
47
Released
Description
All you will need is a necklace chain! A split ring will help the pendant sit on your chest a little bit better, if you have any available.
I would suggest printing this with a .4 nozzle, as walls are thin. Also, a quick blast with a hairdryer will help clean up stringing.
Comment & Rating (7)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Thin, pieces don't all connect. Too flimsy
The designer has replied
0
Reply
Hey there! Did you check the filament and nozzle type? I had no problems using this profile. It isn’t the strongest print (it has a little bit of flex) but it should hold up. Sorry about the bad print!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld