Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
474
1101
122
55
1.6 k
1 k
Released
Description
Spinning snowflake and star
When printed at full scale, the two inner stars are able to rotate freely. At about 70% scale (depending of course on the printer) the tolerances become such that the inner stars can rotate but need a tiny bit of force, so they can be set to desired positions.
Layer height of 0.2mm to 0.3mm recommended
Works fine with PLA and PETG, however with PETG the snowflake might get a little stringy
Presliced files available at 100% and 80% scale.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (122)