My son wanted a swinging target to shoot with his airsoft and BB Gun. I created this target stand and swinging targets.
It has room for 3 Targets, 2 big 1 small.
Updated this version to include
- Cross bar has groove on the bottom to insert into side supports for added stability
- Thicker target hangers (1 snapped when removing it from bed)
- Blocks on bottom of Side supports to reduce Horizontal movement
Instructions
1) Print the Parts
- Print out two of the "supports". I added a block on the bottom of each to prevent horizontal movement of the stand.
- Print out the "Cross Bar" with supports as you will need it because of the rounded sections.
- Print out a set of the targets. You will also need to print it with supports.
2) Snap together the parts
- Remove the support material from the targets
- Snap the targets onto the cross bar
- Insert the cross bar into the square holes on the supports
- align the groove on the bottom of the cross bar with the supports
- and press down to lock in place.