DJI Mini 4 Pro Landing Gear Skid Folding

I wanted to make a landing gear that just clipped onto the bottom of the DJI Mini 4.
And to Lift it a little higher and mostly give it a smaller footprint.

I used carbon fiber pla to keep it light as possible, regular pla will be just fine.

Supports on the bases four clips may be needed depending on your 3D printer, no supports needed on the legs.

Assemble with M2*8 screws and tighten just enough so it can't move around.

Slide and push the rear clips onto the drone and the front will snap into place.

This is a remix. Here is the original
https://www.thingiverse.com/thing:6274636