Chosen

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can change X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.3mm

Filaments Used:
PLA BambuLab Basic White Transmission Distance: 5
PLA BambuLab Basic Grey Transmission Distance: 1
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Black Transmission Distance: 0.3
This print uses 4 unique filaments. Substitute as needed.

Swap Instructions:
Start with White
At layer #8 (0.72mm) swap to Grey
At layer #19 (1.6mm) swap to Blue Gray
At layer #25 (2.08mm) swap to Black for the rest.