Funnels for silica - Drybox for AMS - by Xor-3dpr

Xor-3dpr

3D Printer>3D Printer Accessories

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.2 h

1 plate

4.9(45)

funnels-v2 -including the new small adapter - 0.2mm layer, 2 walls, 15% infill

Designer

1.4 h

1 plate

5.0(17)

new version of adapter for small box -0.2mm layer, 2 walls, 15% infill

Designer

35 min

1 plate

5.0(1)

Open in Bambu Studio

Boost

212

511

303

Released

Description

Update 5/1/2024
I created a wider adapter for the small silica box that makes it possible to fill silica easier. To use it you need to remove the lid of the small silicabox and fill it up. The adapter suits the big funnel.
Both versions of the small funneladapter is included in the -v2 print profile.
-------------------------------------------------------------

I created a funnel for the excellent "Drybox for AMS" (https://makerworld.com/en/models/67281#profileId-71174)

The funnel itself fits the bigger box. Apply the smaller funnel to the bigger and you can use it for the small box also.

Comment & Rating (68)

@Gmac91264

Print Profile

0.2mm layer, 2 walls, 15% infill

This is a great funnel, almost perfect, my only issue is that the attachment is a bit too loose and I feel would fall off if not supported (maybe shrinking 1% would work?). I don’t need that piece for my use but I have to rate on the whole thing. maybe if the base of the funnel had a small lip added that would pressure fit the attachment then it would be perfect.

The designer has replied

@Xor3dpr

Thanks for the feedback. Odd, in my print it fits perfect and its tight to add the attachement to the funnel. Could it be due to differences in the PLA type / vendor?

(Edited)

@aaronbareford

Print Profile

0.2mm layer, 2 walls, 15% infill

No issues, thanks!

The designer has replied

@Xor3dpr

great! Thanks for the feedback!

@maxv

Boosted

Print Profile

funnels-v2 -including the new small adapter - 0.2mm layer, 2 walls, 15% infill

Perfect fit, nice design

The designer has replied

@Xor3dpr

Thank you!

@sgmf68

Print Profile

funnels-v2 -including the new small adapter - 0.2mm layer, 2 walls, 15% infill

sitzt, passt, wackelt und hat Luft :-))

@maxv

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Perfect

@motorola2001

Print Profile

0.2mm layer, 2 walls, 15% infill

Good

@Lucas0560

Print Profile

0.2mm layer, 2 walls, 15% infill

klasse

@volvov80

Print Profile

0.2mm layer, 2 walls, 15% infill

Works good, printed with DevilDesign PLA Dark Grey

@andy1969

The big funnel works perfectly. The smaller adapter gets clogged fairly easily using 3 to 5mm desiccant beads. But a little shaking as it goes in helps out a lot, even though I ended up with a couple dozen renegade beads running around my office because of the shaking. Next time I'll fill them up outside or in a tray. Overall these very useful tools made filling these dryboxes very easy. Thanks!