OLIGHT Baton 3 Pro Max Holster V2
Copyright Claim
OLIGHT Baton 3 Pro Max Holster V2
Boost
4
11
1
Print Profile(1)
0.2mm layer, 2 walls, 20% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
4
11
1
0
14
11
Released
Description
Shortly after creating version 1 I realized it was a bit bulkier than I liked. It functioned fine but I felt like It was “in the way”. So, I decided to make one from scratch.
The little retention nub has a very tight .3mm slit so you will need to be sure your printer is dialed in.
I printed this in PETG with .2mm layer height. I used 20% infill except for the top portion where the “back rest” starts. From that point up I used 100% infill. Not sure if that's necessary.
I didn't try PLA, not sure that would hold up.
I printed this with the bottom on the plate and used supports.
Comment & Rating (1)
All
Print Profile
0.2mm layer, 2 walls, 20% infill
Seems like a sturdy holster, however I had trouble getting the retaining flip freed as it fused with the holster at the bottom. Probably a good choice to use PVA filament in-between.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld