Xtouch or Nerd Miner Desk Stand by charlie.waterworth

charlie.waterworth

3D Printer>3D Printer Accessories

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.9 h

1 plate

4.7(16)

0.2mm layer, 6 walls, 25% infill, Tree support

1.8 h

1 plate

4.7(3)

Open in Bambu Studio

Boost

162

Released

Description

Basic xtouch mount that lets the xtouch screen sit on a desktop or on top of the printer at 35 degree angle (or 55 degree if you flip the screen in settings)

Can also be used for ESP32 2.8inch screen loaded with Nerd Miner for a great looking and cheap Nerd Miner desktop display.

Best printed in Bambu PLA Matte with one of the hex ends on the bed with normal support enabled. Needs 4 small screws (2.5M/3M x 3-5mm) to hold the board into the mount.

nerd miner desk stand

Comment & Rating (25)

@issamu

Print Profile

0.2mm layer, 6 walls, 25% infill, Tree support

Good.

@Brem

Print Profile

0.2mm layer, 6 walls, 25% infill, Tree support

perfect print, used profile with tree supports :D Material: SunLu Pla+ Grey

@n.p.

Print Profile

0.2mm layer, 2 walls, 15% infill

its nice for nerd miner

The designer has replied

@charlie.waterwo

Thanks for the feedback, I hadn't thought of using for anything other than xtouch.

@szlovakricsi

Print Profile

0.2mm layer, 2 walls, 15% infill

(Edited)

The designer has replied

@charlie.waterwo

I've printed a couple of these and not had an issue with removing supports, but someone else in the comments reported having trouble removing them so used tree supports. You could try that.

@szlovakricsi

Replying to @charlie.waterwo :

Yes thank you. It just finnished and works great with tree support if you don't mind i uploaded my print profile for others incase anyone needs it. Otherwise great model.

@charlie.waterwo

Replying to @szlovakricsi :

Thanks, that's great.

@Mistoukwak

Printed in PETG with custom settings. Great design, looks perfect on my desk to have a look on the printer in the workshop. Thanks !

The designer has replied

@charlie.waterwo

Can you post a pic? Would like to see what it looks like in PETG.

@SVCprints

Print Profile

0.2mm layer, 6 walls, 25% infill, Tree support

awesome!!

@Aluuh

Print Profile

0.2mm layer, 2 walls, 15% infill

Thanks for this file to print! works fine

@slick_art

Print Profile

0.2mm layer, 2 walls, 15% infill

Great quick light weight design for your X touch.

@gheorghita.cris

Print Profile

0.2mm layer, 2 walls, 15% infill

great design.

@Rekonnected

Print Profile

0.2mm layer, 2 walls, 15% infill

Originally printed in Bambu PLA Matte with no changes to settings, the support was too dense and too well attached to the part. This resulted in the part breaking when trying to remove the supports. Printed again, this time using Sunlu PETG as a support interface. Additionally, I switched to organic tree supports. The supports then came off cleanly, as expected. Good design overall, thank you!