Cable Hider

Simple cable hider / holder I designed for my daughter to cover USB and power cables she has running along her walls and from the floor to her ceiling that run her security cameras, lights, etc. These can be double-sided taped to the wall, use the small holes to pin them to the walls with little nails or push pins, or use a little hot glue.

I print these in a white PETG so once we place them on the wall, we can just paint them to match her walls. There are several sizes of the center and end pieces. A center piece is a piece that is square on both ends, and an end piece has a taper on one end. There are also connecting pieces to help align the separate pieces and cover up the seems, they fit snugly but should be glued or pained to keep them from falling off.

The Starter kit with alignment clips (PETG).3mf should contain enough pieces and connecting pieces in a single print on the X1Carbon to do a full 8' wall from floor to ceiling. I've included the pieces individually so you can mix and match to get exactly what you want.

In the Starter kit with alignment clips (PETG).3mf I have added custom supports to maintain a good print quality with minimal support and scarring, they do print well without the supports, but the inside of the pieces tend to be a little stringy that way, especially if you scale them up to hold more or thicker cables.