Search models, users, collections, and posts
Sony A7000 Riser
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
4.3 h
1 plate
Open in Bambu Studio
Boost
10
26
1
1
45
24
Released
Description
I needed to get my Sony A7000 sound bar to sit higher on my TV stand, so I put together this simple riser. There is some wiggle room built in to the lips in case of calibration issues. I printed two of these to support the sound bar, you can print a third if you want more support. Tested in draft mode, strength and standard, with PLA and PETG, and no issues with any of those options. I suggest PLA with .2 layer Strength setting, just for added peace of mind.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (1)