A1 Mini Poop/Purge Bucket Bin New Remixed by 3D design shop

Remixed by

3D design shop

3D Printer>3D Printer Parts

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.20mm layer, 3 walls, 30% infill

Designer

8.1 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

160

307

981

Released

Description

However, I found there were many components to print, so I made some changes. I added a side handle to easily flip it upside down into the trash. I chose to reduce its height and assemble it; now it can be printed on one peace. Last but not least, I created my own Poop Baffle.

No assembly requried. no support.

Everything has been thoroughly tested and works flawlessly.

I printed it with a 0.4 nozzle and 0.20 mm layer height, 30% Lightning infill.

Enjoy!'

Comment & Rating (20)

@Stubkjaer

very nice - printed in petg

The designer has replied

@3Ddesignshop

Jeg kan se du har et meget dansk navn. Så du får lige svaret på dansk :P men ser mega godt!

@Stubkjaer

mange tak 😊 har du flere gode ting til den fantastiske a1 mini? 😅

@xKen

Doesn't this part need support? 🤔

The designer has replied

@3Ddesignshop

@xKen

Definitely needs support if you want it to look clean. Not sure why those cutouts are at a slight angle, causing it to print mid-air for two layers before bridging. Probably misaligned the model when remixing it. Should be a simple fix. Other than that, great model, handle makes it very convenient.

(Edited)

@nyknyc

Great model! Thanks for sharing!

@Printerchen

nice! 👍

@imjustjade2020

Print Profile

0.20mm layer, 3 walls, 30% infill

@MusicCity3D

Can you raise the walls a bit in the poop area so it can hold a bit more poop? If I run an all night print the thing is overflowing. Seems like there is about an inch of room to play with to raise the front and side walls a bit under the bed.

The designer has replied

@3Ddesignshop

First I want to say thank you for the support! And of course I will definitely be looking at a version 2.0 keep an eye on it here

@MusicCity3D

Replying to @3Ddesignshop :

Thanks maybe a little wider too. Just big enough to print all night because most multi colored prints out there need to print all day and all night.

@Rmkelly74

it keeps saying “ no content yet”

@angelyyo

best bin

@user_3043977719

hey, first off love your models especially the skeleton dragons and would’ve commented there but it had over 200 and I didn’t want it to get lost, I’ve been looking for someone who could try to make something and thought I’d try you when I say some of your models, is there any way you think you could make an slt (uncolored) of either a lavaback or a deathstalker from the ps game wild hearts, thanks if so rlly appreciate it