.45 Cal Dice and Revolver Cylinder Case Remixed by austinawsomeify

Remixed by

austinawsomeify

Toys & Games>Board Games

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

NEW - 0.16mm layer, 4 walls, 10% infill

Designer

15.9 h

7 plates

5.0(5)

OLD - 0.16mm layer, 2 walls, 10% infill

Designer

7.4 h

2 plates

3.0(3)

Boost

117

Released

Description

I remixed this model for easy multi color printing. (old)

I made the numbers a diff color then the top, but you can just change the filament settings if you want it the same.

I released a new version with options for a numbered bottom and a slot for 5x4mm magnets. (new)

I recommend printing the new profile.

I used these: https://www.amazon.com/gp/product/B0BW8W1XP3/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

Comment & Rating (11)

@elijahbleach

Print Profile

OLD - 0.16mm layer, 2 walls, 10% infill

I will print again, but not from the phone. Going to add a brim. I will change my rating in the future.

Bed Adhesion Issue

The designer has replied

@austinawsomeify

Hey there! Ive never had a failure like that before and ive printed quite a few. However I did release a new print profile with the updated model and better settings for the dice. Give that one a try!

@nikgrunloh

Print Profile

NEW - 0.16mm layer, 4 walls, 10% infill

neat

@dorsai3d

The modeled casings are all slightly different heights, which makes for a bunch more filament changes than necessary, and the baseline print settings with low infill, unsurprisingly, make for loaded dice. The case has markings in the bottom, but the bullets do too, and despite this when the bullet dice are loaded in the case you can't see either marking, and it's very clearly not able to fit them the other way around (lid doesn't meet the case when flipped around, and they're loose). Additionally, the lid doesn't have anything securing it, so it's not so portable on its own. The dice as an idea are really neat, though.

@imnotjames

Print Profile

OLD - 0.16mm layer, 2 walls, 10% infill

This profile uses a 10% infill which leads to the dice being severely loaded -- I assume with 100% it'd be SLIGHTLY better but they'd never be perfect. The case is a really cool idea but doesn't actually stay closed. I'll probably need to modify it to somehow fit in some small magnets to keep it closed. The dice themselves are pretty cool. I used some overture silk metallic looking PLA for it.

The designer has replied

@austinawsomeify

Feel Free to check out the new profile. I've included 4 different case versions. Ones with and without magnets. And ones with and without numbers on the bottom. It uses 5x4mm Magnets.